![]() ![]() Later in terminal ( TERMINAL_STATE 1): sudo ifconfig eth0 ifconfig NOTE: There is no IP address in the line after eth0. TX packets:1800 errors:0 dropped:0 overruns:0 carrier:0 RX packets:4195220 errors:0 dropped:0 overruns:0 frame:0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 In terminal ( TERMINAL_STATE 0): ifconfigĮth0 Link encap:Ethernet HWaddr 08:00:27:b3:ed:c7 ![]() The network settings of the Ethernet adapter set from automatic IP address to manual IP address selection with: The scanner is connected to the Mac Pro directly over ethernet cable.ġ) The ethernet connection gets disconnected and the ip needs to be set again to reconnect.Ģ) How to permanently set a static ip to the bridge adaptor connection?ĭevice connected on ethernet (scanner) demands: ![]() I’m trying to connect to a ethernet device (like a scanner/printer) to a guest Ubuntu 12.04 running on Virtualbox 4.3.12. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |